P0346 OBD Engine Code Logo   Code #P0346 -
Camshaft Position Sensor 'A' Circuit Range/Performance (Bank 2)

Select a Code:


The P0346 error can be caused by a clogged or failed camshaft position valve.

If your car is an Audi, its likely to be a clogged camshaft position valve as Audi as released bulletins and recalls related to it.

replaced cam sensor. erased code and light went out. 2 days later light came on again. It goes out and on again in a few days.

ENGINE RUNS FOR 20 MINS. THEN IDLES UP CUTS OFF AND HARD TO RESTART. AFTER 3 MINS OR SO IT STARTS

Volkswagen Passat
2000 2.8. Removed cams to fix oil leaks from cam positioner. maybe I over squeezed the cam positioner an broke it?


Hyundai Santa Fe
i ahve an fault code display for my car p0346


engine died will not start

p0346

THE CAR STARTS BUT IT DOESNT CHANGE GEARS

Saab 9-5
p0346


Saab 9-5
P0346


P0011

cel is on, no symptoms

Was in 3rd gear at 5500rpms accidentally shifted into 2nd gear instead of 4th, that's when this code came on. Car: 2014 Subaru Impreza WRX Limited - 5 speed.

have a 2004 Isuzu Rodeo 3.5 no start will crank but will not start had no spark at coils i replaced crank sensor and spark plugs now have spark it did start 2 times but shut off with in 5 sec. getting DTC P0346 but only after i crank 4 a good time. has new cam sensors did not replace my self tho but i have switched them around will start but then die what the hell!!!

No spark



Report your Experience!

Tell us about Code #P0346

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0706 Acura 3.2TL
po705 po706 intermitting start


P0337 Kia sorento 2004 shutdown while driving Show PO128, PO183, PO337 code Fuel pump change Crankshaft sensor change still shutting down

P0421 Mitsubishi Eclipse
p0421


P0882 wont change gears

P0942 Alfa Romeo 159
Me aparece error y no se que es




Other Check Engine Light Codes

P0030   HO2S Heater Control Circuit (Bank 1 Sensor 1)
P0100   Mass or Volume Air Flow Circuit
P0157   O2 Sensor Circuit Low Voltage (Bank 2 Sensor 2)
P0372   Timing Reference High Resolution Signal 'A' Too Few Pulses
P0506   Idle Control System RPM Lower Than Expected
P0600   Serial Communication Link
P0631   VIN Not Programmed or Mismatch - TCM
P0896   Shift Time Too Long
P0938   Hydraulic Oil Temperature Sensor Range/Performance
P0947   Hydraulic Pump Relay C ircuit Low




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.