P0103 OBD Engine Code Logo   Code #P0103 -
Mass or Volume Air Flow Circuit High Input

Select a Code:


service engine soon

Audi A6
Rough idle


Nissan Pathfinder
p0103


Suzuki Sidekick
I have a used Suzuki Sidekick (DX). Car does start, but stop sometime. It doesn't stop frequently; only once in a while.


Hummer H3
Cylinder 1 misfire


BMW Z4
P0103 Mass or Volume Air Flow Circuit High Input


Just replaced spark plugs and coilpac

Jeep Cherokee
Came on at 77, 000 miles


seadoo

the rialta motorhome wants to shut off when you press down on the gas pedal.

Winnebago Rialta
code po 103 comes up my code reader


i do not have any

check engine light on. code P0103 came up using obd 2 scanner

Hyundai Tiburon
car do shake when travelling at 50-60 mph


The "Service Engine Soon" Light came one. Code reader said P0104.

black smoke,,wont accelerate,,alao codes po136,p1451,po172

engine poping when accelarating

MUCHO HUMO NEGRO Y NO ACELERA



Report your Experience!

Tell us about Code #P0103

When did your Check Engine Light Come On?
Does your Car Start?
Does your Car Vibrate? Shake?
Does your Car Idle Roughly? Reduced Power?

Even if you don't know the fix, please provide us all details about your experience to help others!
Make:
Model:
Comments:
 


Other Comments

P0775 need help in locating b valve solenoid or do i need the tcm that goes with that tranny

P0775 Nissan Maxima
i just put in a used tranny it does not go forward or reverse got engine code p0775 no b solenoid presure my trip tronic gear stuck on five please help


P0863 Ford F-250 Super Duty
engines check light code PO863


P0841 Stuck in park... 2008 Jeep commander sport/xk 4.7L V8 automatic. Symptoms: Shift lever physically moves when attempting to shift from park to reverse, neutral or drive, there is no mechanical action in transmission. Causes engine RPM to fluctuate between 400-700 RPM for 5-20 seconds then idles at a consistent 600 rpm. I have crawled under the jeep while someone is attempting to shift (from park to reverse, neutral and drive) and watched the mechanical linkage moving on the side of transmission. The only error code that pops on the OBD 2 reader is: p0841 transmission fluid pressure sensor.

P0842 when I start the car and put it drive it takes off normal but when it shifts to the other gear it jumps and is alittle sluggish but it shifts again and goes back to normal again



Other Check Engine Light Codes

P0075   Intake Valve Control Solenoid Circuit (Bank 1)
P0223   Throttle/Pedal Position Sensor/Switch 'B' Circuit High Input
P0346   Camshaft Position Sensor 'A' Circuit Range/Performance (Bank 2)
P0373   Timing Reference High Resolution Signal 'A' Intermittent/Erratic Pulses
P0421   Warm Up Catalyst Efficiency Below Threshold (Bank 1)
P0485   Cooling Fan Power/Ground Circuit
P0550   Power Steering Pressure Sensor Circuit
P0870   Transmission Fluid Pressure Sensor/Switch "C" circuit
P0905   Gate Select Position Circuit Range/Performance
P0993   Transmission Fluid Pressure Sensor/Switch "F" Circuit Range/Performance




Others were Searching For...


Warning: mysql_fetch_assoc() expects parameter 1 to be resource, boolean given in /var/www/OBD/404error.php on line 380





Home - Contact Us
All Content and Images are Copyrights of their respective parties. Copyright SellHI, LLC.